Carbon JK Non-Rubicon Front D30 27 Spline Axle Kit (C0006) – Jeep Wrangler JK 2007-2018 (Non-Rubicon) If you drive a Wrangler JK Non-Rubicon and want to increase the strength of your Dana 30 front axle, this Carbon Offroad by MetalCloak halfshaft kit is a concrete upgrade “for years to come.” You get a set of two halfshafts (left + right) made from 4340 Chromoly steel and prepared for quick installation. The kit comes ready to install (no work on the press) and uses Spicer’s large 5-760X series cross joints – designed to hold grease and reduce debris entry in rough terrain.
Compatibility Jeep Wrangler JK 2007-2018 (Non-Rubicon) Bridge / polygon Front Dana 30, 27 spline Half-axle material Steel 4340 Chromoly, double heat-treated Bolt-in assembly, no press work Product photo A set of front half-axles for D30 – a solution focused on off-road durability.
Key benefits – Significantly higher strength and overload resistance compared to stock halfshafts (more than 50% stronger than stock, according to the manufacturer) – 4340 Chromoly steel with double heat treatment – spare durability for heavier conditions and higher drive loads – Bolt-in kit: halfshafts come assembled and ready to install – no “press work”.
– Large Spicer 5-760X Spicer 5-760X universal joints: solid body, hardened bearing cups and seals to hold grease and limit dirt inside. – Set of two halfshafts (driver + passenger) – consistent upgrade of the entire front end.
Detail: Spicer 5-760X Spicer 5-760X joint – a critical component for drive durability in the field.
What’s in the kit – Left front halfshaft (driver side) for Dana 30, 27 spline.
– Right front half-shaft (passenger side) for Dana 30, 27 spline.
What’s in the kit – Spicer 5-760X series universal joints – assembled, with clips, ready for installation.
Specifications / facts – Product: Carbon JK Non-Rubicon Front D30 27 Spline Axle Kit – Product ID: C0006 – Compatibility: Jeep Wrangler JK 2007-2018 (Non-Rubicon) – Bridge: front Dana 30, 27 spline – Axle material: 4340 Chromoly steel – Treatment: dual heat treat – Joints: Spicer 5-760X Series U-Joints – Installation: bolt-in, no press required Half-axle kit – intake Complete (left + right) – ready to install.
For whom / application – For owners of Jeep Wrangler JK Non-Rubicon, who want to strengthen the front Dana 30 (27 spline).
– For off-road driving, where serial half-shafts are sometimes a limitation (higher drive loads, difficult climbs, rocks, ruts) – For people who want a “plug-and-play” solution without additional workshop work on the press. Installation / notes – The kit is intended as a bolt-in installation and does not require work on the press.
– Before purchasing, confirm that you have a non-Rubicon Dana 30 front bridge and a 27 spline polygon. Summary (for content scan) – Jeep JK 2007-2018 Non-Rubicon + Dana 30 front (27 spline). – 4340 Chromoly + double heat treatment. – Set of two halfshafts (L+P) + Spicer 5-760X joints. – Bolt-in installation, no work on the press.
